0 Comment

cement plaster (stucco) wall claddings as specified by ASTM stucco industry standards. Standards ASTM C and ASTM C were carefully researched by. Lathing and furring accessory and fastener installation requirements remain in C as well. This standard does not replace ASTM C violation of the building code IBC and FBC referenced ASTM. C, which establishes the requirements for stucco applied over a metal plaster base a.k.a. lath.

Author: Fenrigrel Moogugar
Country: Germany
Language: English (Spanish)
Genre: Literature
Published (Last): 20 November 2015
Pages: 152
PDF File Size: 17.17 Mb
ePub File Size: 5.86 Mb
ISBN: 245-9-21693-430-3
Downloads: 90910
Price: Free* [*Free Regsitration Required]
Uploader: Tojamuro

The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

Work Item s – proposed revisions of this standard. Historical Version s – view previous versions of standard. Little can be reached at c.

The new standard is available and ready at astm. The following materials shall be used: He has 20 years of experience in new product development and technical support, and has also played an integral role in helping shape industry standards for lathing and plastering, as well as installation of masonry stone veneer. Little is senior product manager at ClarkDietrich Building Systems.


A New ASTM For Plaster Accessories

The following methods are discussed: Lathing and furring accessory and fastener installation requirements remain in C as well. Hangers and cold-rolled channel main runner shall conform to the allowable spacing and spans, respectively.

This abstract is a brief summary of the referenced standard.

Link to Active This link will always route to the current Active version of the standard. With a copyright, the document is not to be duplicated without ASTM permission. This specification covers the installation of lathing and furring to receive interior and exterior Portland cement-based plaster.

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. The Stucco Work Group meets virtually via webinar and review items that have been proposed, make suggested changes and then develop those into ballot-worthy items for the ASTM committee to vote on ast, semi-annual basis.

It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.

Since its formation inthe ASTM C11 Stucco Work Group has worked toward reconciling inconsistencies in current standards and creating new standards that reinforce consistency in the stucco industry. This new standard will be useful to a wide spectrum of stakeholders, including building owners, specifiers, engineers, architects, manufacturers, and applicators throughout the industry.


These were included to provide basic guidance on the shape or appearance of the accessories; both old and new. These requirements do not by default define a unit of work or assign responsibility for contractual aastm, which is the purview of a contract or contracts made between contracting entities.

WallsandCeilings – September 2018

This specification contains the minimum requirements for lathing and furring accessories, fasteners, etc. Looking forward, the SWG is now developing requirements that will fill the significant needs of building owners, designers, and craftsmen in the stucco industry for the use of continuous insulation and drainage, addressing other important stucco industry topics.

ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

This page can be found at http: The standard is listed under C