0 Comment

The DS/DSA are quad line receivers Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet. The DS/DSA are quad line receivers designed to .. Reproduction of TI information in TI data books or data sheets is permissible. D Input Resistance 3 kΩ to 7 kΩ. D Input Signal Range ±30 V. D Operate From Single 5-V Supply. D Built-In Input Hysteresis (Double. Thresholds).

Author: Maulkis Akinokazahn
Country: Barbados
Language: English (Spanish)
Genre: Sex
Published (Last): 7 February 2016
Pages: 284
PDF File Size: 12.1 Mb
ePub File Size: 1.24 Mb
ISBN: 214-1-94905-689-9
Downloads: 59115
Price: Free* [*Free Regsitration Required]
Uploader: JoJokree

In addition, the voltage reference input can be adjusted to allow encoding any smaller analog voltage span to the full 8 bits of resolution. The LM series has internal unity gain frequency compensation. Monday, March 17, tl TI datasheet download pdf. ANational Semiconductor.

Features n TTL input compatible n Typical propagation delays: Posted by Datasheet at 5: Further, a single capacitor can be added to reduce the 0. LNational Semiconductor. All inputs are protected against damage due to electrostatic discharge by diodes to VCC and ground.


Quad Line Receiver

Share to Twitter Share to Facebook. This part uses special output circuitry that enables the drivers to power down without loading down the bus. DNational Semiconductor. They are constructed on a single monolithic silicon chip.

Designed primarily for power-supply control, the TL provides the systems engineer with the flexibility to tailor the power-supply control circuits to a specific application. However, unlike most internally compensated amplifiers, external frequency compensation may be added for optimum performance. This enables the construction of serial and terminal interfaces while maintaining minimal power consumption.

DS Datasheet(PDF) – National Semiconductor (TI)

The outputs share a common source supply and common power ground terminals, which allow system designers to eliminate errors caused by high current-induced voltage drops and common-mode noise. This considerably simplifies its application since no external components are datassheet for operation. Overcompensation can be used with the amplifier for greater stability when maximum bandwidth is not needed. This device has enable and disable circuitry common to all four drivers.


Posted by Datasheet at SPiKe protection means that these parts are safeguarded at the output against overvoltage, undervoltage, overloads, including thermal runaway and instantaneous temperature peaks.

The TL contains two error amplifiers, an internal oscillator externally adjustablea dead-time control DTC comparator, a pulse-steering flip-flop, a 5-V precision reference, undervoltage lockout control, and output control circuits. Two totem-pole outputs provide exceptional rise- and fall-time performance for power FET datashset.

They feature a factor of ten increase in speed over general purpose devices without sacrificing DC performance. Differential analog voltage inputs allow increasing the common-mode rejection and offsetting the analog zero input voltage value.